Rate this post by selecting a number. 1 is the worst and 5 is the best.

Author Message Michael McKellar Tinkerer Overijssel Mini Posts: 71 Reg: 08-2008   Rating: N/A Votes: 0 Friday, March 18, 2011 - 10:03 pm, by:  Michael McKellar (Mickmini) Ben Lipman wrote on Sunday, March 13, 2011 - 08:31 pm: Here is a link to wool tufting a Soarer. Not being an expert on the stuff, I think the top of guard vent would work fine. The one behind the wheel arch might actually work too. If nothing else it may clean up that area. http://soarercentral.com/sc-forum/messages/283/284909.html Ben, Looking at wool tufts to show where flow is laminar or turbulent is all fine, but it does not tell you what you need to know. You want to know where the best pressure difference between the locations of the inlet and outlet of your cooler. Back to that manometer again. Read this series on Autospeed http://autospeed.com/cms/title_Ultimate-DIY-Automotive-Modification-ToolKit-Part-3/A_111111/article. html Measure it before you cut holes. cheers michael

Administration      Log Out