Last x Days Posts  1 | 3 | 7 Days  Search  Topics  Tree View  Help

Rate this post by selecting a number. 1 is the worst and 5 is the best.

    (Worst)    1    2    3    4    5     (Best)

Author Message
Allan Langford
TryHard
Vic
UZZ31

Posts: 480
Reg: 05-2010

Top of pagePrevious messageNext messageBottom of page Link to this message

Rating: N/A
Votes: 0

Monday, July 18, 2011 - 12:18 pm, by:  Allan Langford (Allan)

If your are going to use it to make a mold I would of actually leave the side flat into the intercooler and then after you make your copy just hole saw where you want the ducts in the final piece (also angling the ducts will reduce the chances of ducting a stone into your disc / caliper), this would make it much easier to separate later on



Ben Lipman wrote on Sunday, July 17, 2011 - 09:02 pm:

Alan, yeah it is. I have 'ovalled' it during the sanding and so on. I was going to leave them to the end and then use something to get them both back to properly round. I also want to fit some 63mm pipe to extend out the back to make it easy to fit the ducting hose onto when fitting the bar at the track.


  Administration Administration      Log Out Log Out