Rate this post by selecting a number. 1 is the worst and 5 is the best.
Author
Message
Andrew McKellar DieHard NSW Soarer Sports Sedan (well, nearly)
Posts: 529 Reg: 06-2008
Rating: N/A Votes: 0
Friday, January 06, 2012 - 06:53 am, by: Andrew McKellar(Toymax)
Great stuff.
When it comes time to make the parts, do the inner skeleton first. Trim it up and try it for size and fit in the mold for the outer skin. Then do the outer half and while the resin is wet press the skeleton into it and clamp it until the resin goes off.
That will provide a much better bond than any adhesive you try to apply later.
