Last x Days Posts  1 | 3 | 7 Days  Search  Topics  Tree View  Help

Rate this post by selecting a number. 1 is the worst and 5 is the best.

    (Worst)    1    2    3    4    5     (Best)

Author Message
Lawrence Ostle
TryHard
NSW
tt

Posts: 461
Reg: 12-2005

Top of pagePrevious messageNext messageBottom of page Link to this message

Rating: N/A
Votes: 0

Tuesday, December 25, 2007 - 08:00 pm, by:  Lawrence Ostle (Lawrence)

Woah, hang on!

The instructions I wrote up were ONLY to remove the seats from the car. This involves removing the clip-on plastic trims that cover the seat-rails bolts. These can be removed using a flat screwdriver gently, to prise them lose. Once this is done, you can see the five bolts that secure the rails to the floorpan of the vehicle. Remove the seats from the car as described.

THEN the instructions say:

"You will probably want to remove the plastic shroud at the base of the seat to get the best fit. I didn’t as it is quite tricky, and used a plastic ruler to push the seat covers between the seat and the plastic shroud"

However, once the seats are out, you should be able to remove the plastic trim at the base of the seat. But as I note, I didn't do this, and it was fine.

  Administration Administration      Log Out Log Out