Last x Days Posts  1 | 3 | 7 Days  Search  Topics  Tree View  Help

Rate this post by selecting a number. 1 is the worst and 5 is the best.

    (Worst)    1    2    3    4    5     (Best)

Author Message
Ryan Posselt
TryHard
NSW
Celsior V8

Posts: 366
Reg: 08-2006

Top of pagePrevious messageNext messageBottom of page Link to this message

Rating: N/A
Votes: 0

Tuesday, March 03, 2009 - 08:47 am, by:  Ryan Posselt (Yakusaryan)

Hey,
I went backwards...
located the controller on the removable panel under the trip computer.
Though the gap in the steering column and dash.
Under the carpet behind the pedals
Around to under the drivers side door sills (they just pop off)
Pull out the back seat:

lift the bottom up and out, beware of the wiring harness attached to the floor
two bolts visible where the bottom of the seat was
one bolt behind a zipper behind the outer side of the headrest
two bolts behind the centre armrest - Pull the cloth/MDF trim upwards and then out to avoid breaking the MDF

The lead then ran up through a tiny square hole located near the air filter.
Through the whole in the boot trim where the boot hinge lives
behind the small cupboard thingy :-)
to the suspension controller

I stuck my unit on with adhesive velcro works well!

Its an easy job takes 30 - 40 minutes.

Goodluck

  Administration Administration      Log Out Log Out