Rate this post by selecting a number. 1 is the worst and 5 is the best.

Author Message Peter Nitschke Moderator GT4.0 V8 Posts: 1322 Reg: 11-2004   Rating:  Votes: 1 Thursday, September 01, 2005 - 02:50 am, by:  Peter Nitschke (Pen) How to Replace a Window Regulator Tutorial kindly provided by Perry Morgan 1. Undo 3 bolts on brace. Undo and unclip the brace. 2. The brace removed showing broken window regulator. 3. The 2 four slotted disks must be undone anti clockwise. 4. Undoing the disk the bush mechanic way. [Needle nose pliers might be easier - Pen] 5. Slipping the regulator off the window glass. 6. Lift the glass up out of the way and tape it there. 7. Remove the 3 gold nuts. 8. Remove covers to access the nuts that hold the regulator to the door. 9. Remove the 3 nuts to undo the regulator. 10. Unclip the harness where it is attached to the door. 11. You may need to push the bolts out as they are hard. Then remove the regulator from the door. 12. The new regulator. If replacing with a NEW regulator follow these steps. Otherwise follow the previous steps in reverse order to install. 13. Cut the zip tie. 14. Carefully remove the transport cover. 15. Remove old regulator from motor by undoing metal plate. 16. Lever the regulator (white parts) from the motor. Careful as it can flick out as it is under tension. 17. Fit new regulator to motor. 18. Replace the old style cap (on left) with the new one supplied with the regulator. 19. Screw on new cap to hold regulator in place. Now you are ready to go back and install.

Administration      Log Out