Thursday, April 06, 2006 - 08:13 pm, by: Ben Socratous(Socrates)
Seeing as my power steering and tranny oil hoses are looking a bit taddy (I'm sure they're about to go any day now) I'm wanting to replace them when I put in my new coolers.
Just wondering if anyone can tell me the inside diameter for the respective hoses as this would save me puling them off just to measure them, and dumping fluid in the process.
Sunday, April 09, 2006 - 01:31 pm, by: Avin Luther(Lex_luther)
ben, the trans cooler i fitted yesterday had 5/16" hoses on it and they were just too small (they fit over the pipes, but it was a bloody tight squeeze)
I seem to recall 10 mm mentioned? but dont take my word for it.. sounds big.