Tuesday, August 30, 2005 - 08:54 pm, by: Ben Kelly(Ace)
I have got a new set of 17" wheels which replaced an old set. Thing is someone told me that the offset is probably wrong. The wheels also havent been aligned yet should i use the factory settings considering a different wheel size? Are there settings which will compensate for the lack of offset or too much?
Saturday, September 03, 2005 - 01:47 pm, by: Ben Kelly(Ace)
Im not sure what the offset is or how to find out, but im pretty sure that whatever it is i dont have enough of it as i get a fair bit of tramlining. Can anyone recommend a good alignment place as i have been told that a lot of places know bugger all about camber/castor settings
Can anyone tell me a soarer wheel alignment expert near Caboolture Qld. and how much they cost? I got Fulcrum at Caboolture to do it but am not sure that they knew what they were doing as the guy didn't know the rear needed doing, I had to tell him even after I had given him a piece of paper with the specs on it. I have just fitted new tyres and don't want them wearing unevenly. Cheers John
Both the lateral LCA's control toe and camber so getting everything back there to line up in a 15-20 year old car that may or may not be using original bushes can be hard. Especially hard if you don't see Soarer's often.