Saturday, May 26, 2012 - 10:24 am, by: Dave Rose(Sand_groper)
Cant see all 4 being wrong , its looking like the height computer is u/s, i would disconnect one rear rod have fully down (hanging) try that first,next i would check the height switch and connections (it may be stuck on high)try it disconnected.
Saturday, May 26, 2012 - 09:47 pm, by: Greg Wyllie(Bearshead)
Dave, I replaced the height switch recently but with one from the wreckers so it is 21 years old as well! What should happen when I disconnect it?
Do the height computers play up after a while? Do I replace this one or is it better to have it repaired?
Lastly as the airbags have stayed fully pumped even after many weeks of non-use is that a good indication of their condition/performance once i get this height control issue sorted out, thanks
Sunday, May 27, 2012 - 09:45 am, by: Greg Wyllie(Bearshead)
I got a bit scientific this morning and measured floor to top of wheel arch......the height switch is working but difference between high and normal is only 15mm, if this about right? The pump only cuts in for a few seconds and is super quiet, I was expecting it to be 50mm or more
Sunday, May 27, 2012 - 11:58 am, by: Dave Rose(Sand_groper)
Greg ,i agree with Tom ,it looks a bit high but not what i was thinking ! follow the link (just do one front wheel to find out if it works) as you can adjust it with out removing the wheel or jacking, http://soarercentral.com/sc-forum/messages/67/468.html?1099559368