Monday, March 02, 2009 - 06:57 pm, by: Ryan Seddon(Ahrjay)
I got a height controller a while back but hadn't had the time to put it in, I only just hooked it up and tested it out. Where do you run the cable to get it through to the front? Do I need to take the back seat out to run a cable or is it a lot simpler than that?
Joe Russell TryHard Marlborough 4.0 V8 GT-L(UZZ31)
Tuesday, March 03, 2009 - 04:32 am, by: Joe Russell(Joe_r)
You do, just to access the suspension computer and be able to take the trim off. My cable goes along the passengers sill and up behind the glove box then into my centre console area. It's quite easy to do, just follow the other cables there.
Tuesday, March 03, 2009 - 08:47 am, by: Ryan Posselt(Yakusaryan)
Hey, I went backwards... located the controller on the removable panel under the trip computer. Though the gap in the steering column and dash. Under the carpet behind the pedals Around to under the drivers side door sills (they just pop off) Pull out the back seat:
lift the bottom up and out, beware of the wiring harness attached to the floor two bolts visible where the bottom of the seat was one bolt behind a zipper behind the outer side of the headrest two bolts behind the centre armrest - Pull the cloth/MDF trim upwards and then out to avoid breaking the MDF
The lead then ran up through a tiny square hole located near the air filter. Through the whole in the boot trim where the boot hinge lives behind the small cupboard thingy to the suspension controller
I stuck my unit on with adhesive velcro works well!