Tuesday, September 06, 2005 - 04:23 pm, by: Sean Butler(Pyro_15)
i have a simular problem and put it down to heat. i left my 91tt in the sun all day where i was doing some training and when i got back i'd start her up (insinde was bakeing) and the o/d would flash and send up a red warning. turn on the fans for 20 sec to move the hot air and volah all better. mabyt the circuit has some thermal overloads in it????
Tuesday, September 06, 2005 - 08:02 pm, by: Anthony El-Khoury(Mushu)
Kevin,
Had a very similar problem last week, the O/D would flash when the ECT was enabled and got the ECT error message on the dash. Turned out to be I was earthing something that didnt need to be earthed. If you have been fiddling with anything of late (thats how I did it), then more than likely thats something is earthed that shouldnt be earthed. Have a look around the usual earth points and you may just find whats going wrong.