Author |
Message |
gerald barwick
Newbie V8
Posts: 1 Reg: 08-2005
| Hey Guys bought my dream car and its turning out to be a nightmare... help please I have a 1992 uz31. I had pump steering leaks and fixed that... changed the power steering pump. I then changed the timing belt and the tensioner. I then had water pump probs, it was leaking, so I fixed that. Went for a test drive, power steering fluid was still leaking. So had look from under the car and saw that the Weird shaped power steering piping, (its a long piece with rubber hose and metal piping connects to the pump i think) that maybe the pressure hose of the power steering, that had a leak ( a small hole) Telephoned Lexus dealers they asked for $500 to repair. anyway fixed that... now took it for a test drive and the car misses. When cold it drives fine, but 5 mins later the car starts to jerk and miss. Also the A/c piping froze, so I turned the A/C off. Thought that was the problem. car still jerks. I dont know what it could be. COuld it be any of the pressure connectors that relates to power steering or water pump?? I dont know why the A/C piping froze. I dont know why the car jerks and misses. PLEASE guys any suggestions |
Peter Nitschke
Moderator GT4.0 V8
Posts: 1295 Reg: 11-2004
| Gerald, AC pipe freezing is normal, just means the AC is doing it's job nicely. Not sure about the real problem though. Others will probably have more thoughts as the day wears on. |
Benny Gammelmark
TryHard V8 UZZ31
Posts: 423 Reg: 07-2005
| Gerald, Wait for others to respond but if you in the end have no luck then go to Niall Bond in Botany. He's the Sydney guru on Soarers and will also service the car cheaper than most. Contact details: Bond Auto Tech 3/2 Hale Street Botany, NSW 2019 Phone 9666 6364 Good luck. |
Peter Nitschke
Moderator GT4.0 V8
Posts: 1297 Reg: 11-2004
| Gerald, just read your profile, how serious is your plan to twin turbo the V8? |
Neil Griffiths
Trader 1 x JZZ30,2 x UZZ31,1 x UZZ32,1 x UZZ Track Car,1 x AeroCabin,1 x Crown V8,1 x Celsior
Posts: 253 Reg: 07-2005
| Possably crook HT lead ??(You MAY have jammed it when re-installing the parts after doing cam belt !! ) Best go for lap over to Niall |
Jeff Harper
Trader UZZ32 Active V8
Posts: 309 Reg: 07-2005
| did you wash the motor? It may be water in the plug holes, or buggered HT lead. |
Gerald Barwick
Newbie V8
Posts: 2 Reg: 08-2005
| Actually I did wash the motor after degreasing it. so I will look into that this arvo. will advise if things change. please keep making suggestions. regards barwick |
Jeff Harper
Trader UZZ32 Active V8
Posts: 312 Reg: 07-2005
| That will be your problem for sure, water in the plug holes. |
Gerald Barwick
Newbie V8
Posts: 3 Reg: 08-2005
| Ok guys a quick question... if it was just the water in the plug holes wouldnt it make it difficult to start as well... rather than just miss when its hot?? |
Jeff Harper
Trader UZZ32 Active V8
Posts: 314 Reg: 07-2005
| look 1st, then get philosophical! Where in Sydney are you? I'm in Cherrybrook. |
Gerald Barwick
Newbie V8
Posts: 5 Reg: 08-2005
| I am in seven hills. I will do as you said jeff. Will check out the plug holes, then the HT leads... if they dont work.. i will be back at you Jeff for further advice. |
Jeff Harper
Trader UZZ32 Active V8
Posts: 315 Reg: 07-2005
| HT leads are cheapest from Neil Griffiths. |
Gerald Barwick
Tinkerer V8
Posts: 6 Reg: 08-2005
| JEFF AS PER USUAL... YOU WERE ABSOLUTELY RIGHT. couldnt get the leads as it would take too long so bought it local. Car doesnt miss any more.. BUT I HAVE ANOTHER PROBLEM NOW..... its the POWER STEERING the POWER STEERING does not work when the car is reving at less than 1200rpm When at high revs the car is perfect. I thought it must have been the vacuum hoses so i replaced them, BUT still the same prob. ANY Suggestion guys. Also My friend suggested replacing my injectors as they were factory ones... I upgraded my Injectors to the plug and play fitting Supra 7MGE 315cc/min, what now happens is that the ENGINE ELECTRICAL SYSTEM light comes up. (obviously its in japanese) but thats what it says. Could it be the injectors or some faulty electrical work. help pelase |
Rob Andreacchio
Moderator UZZ31 V8 / JZZ30 TT
Posts: 315 Reg: 01-2005
| could be the PRV inside the PS pump getting stuck... or could be the pump itself dying... Try replacing the valve first off, and then if that fails, change the pump. |
Gerald Barwick
Tinkerer V8
Posts: 8 Reg: 08-2005
| Thanks Rob... But I just serviced the pump about two weeks ago. will look into the valve issue... can i get it serviced or changed... just one thing is this the same valve where the Vacuum hose fits?? any idea where I can get them... |
Neil Griffiths
Trader 1 x JZZ30,2 x UZZ31,1 x UZZ32,1 x UZZ Track Car,1 x AeroCabin,1 x Crown V8,1 x Celsior
Posts: 320 Reg: 07-2005
| Ya car drink lots & lots of petrol now.. Its gunna fuel up at 60kph... ECU CANNOT learn 315cc Injectors V8 IS NOT the same as a TT |
Rob Andreacchio
Moderator UZZ31 V8 / JZZ30 TT
Posts: 317 Reg: 01-2005
| Neil knows all about the valve... heheh.. that is what he changed for me on his Birthday a few years ago...Just before winning the $50K scratchie hahahaha |
Gerald Barwick
Tinkerer V8
Posts: 10 Reg: 08-2005
| yeah I am heading to a TT ... just waiting on one part to be delievered then will get the modification done. They said there was a 1 month delay... so thats my hold up. Neil any suggestions on the valve. please |
Neil Griffiths
Trader 1 x JZZ30,2 x UZZ31,1 x UZZ32,1 x UZZ Track Car,1 x AeroCabin,1 x Crown V8,1 x Celsior
Posts: 321 Reg: 07-2005
| Reepa,,They got some girl the same way,,hehhe EXCEPT..she was video'd and put on TV... I dont think her husband gunna get a bit for a VERY long time..hahahahhaha |
Neil Griffiths
Trader 1 x JZZ30,2 x UZZ31,1 x UZZ32,1 x UZZ Track Car,1 x AeroCabin,1 x Crown V8,1 x Celsior
Posts: 322 Reg: 07-2005
| Maybe valve filter screen dirty ?? (Although this shoulda been cleaned when rebuilding) |