Tuesday, September 16, 2014 - 04:40 pm, by: Darren Bak(Dmb169)
Hello, this post is so i can have all the information i need in one place to install an aftermarket head unit while maintaining the stock speakers/amp.
I have a single din pioneer head unit (few years old) it has rca which i had an amp/sub connected to (previous car), i have the connection wires for it and have seen some early model toyota ISO wires, that say fit an toyota MR2, which i read somewhere can be used for the soarer.
if that works how would i go about connecting the stock amp to the rca ports
Friday, September 19, 2014 - 03:00 pm, by: Darren Bak(Dmb169)
got stuff temporarily wired up, i can get audio from the speakers but not the sub, i used this guide
1 = AMP - Pink and Blue 2 =(not in use) 3 = ACC - Grey 4 = B+ 12v constant - Black and Yellow 5 = Mute... handy to know :-) if you have the stock amp. - Yellow 6 = Front Left + = Black? 7 = Front Right + = Red 8 = Ant Amp PWR = Black and Red 9 = (not in use) 10 = (not in use) 11 = Ground - Brown 12 = Signal ground - Brown and Black 13 = Audible warning Beep? - Green 14 = Rear Left + = White 15 = Rear Right + = Brown... two browns on a single plug...?
one wire that i cant connect is the number 8 wire *antena.
the sub may/not be working its hard to get my head ovr it to listen but its either nor working or is working but not playing the low end.