Tuesday, May 22, 2012 - 08:58 pm, by: Aaron Casey(Blownminiturbo)
Hey people, ive been installing some gauges and i have a air/fuel ratio gauge i wish to install. i have found some pin out diagrams, but then i pulled ecu cover off and have found i have the 40p 40p 40p connectors not the 28p 16p 22p 34p, i dont want to run the wire to the sensor and at the moment its not parked in a place to get underneath and start doing continuity testing and finding it myself, plus its quite cold at the moment after work. any help or secret link would be great. i cant seem to find one.
Tuesday, May 22, 2012 - 09:26 pm, by: Aaron Casey(Blownminiturbo)
walter, yes my uzz31 track car has the 3 pin v8 ecu. i stole the autometer air/flow ratio gauge out of my jzz30 as i will be replacing it with a wideband setup.
only pinout i can find for the 3 pin uzz31 is here: http://www.v8soarer.com/map-ecu/index.shtml and is the same in the apexi safc install guide. so doesnt show o2 sensor pins.
strange that so many v8's are around and pinouts are extremely hard to find.
Tuesday, May 22, 2012 - 11:39 pm, by: Aaron Casey(Blownminiturbo)
wow thanks walter! is that from soarer bible? i may have to invest in it soon haha ill do some measurements tomorrow lunchtime. couldnt start it tonight to get readings as will wake the block up as off at headers haha
Wednesday, February 27, 2013 - 08:08 pm, by: Andy Losurdo(Funny_guy77syd)
can u please email me those photos of the ecu pin outs for the uzz31 i think since my manuel conversion my aircon when its on the idle drops and goes below normaL IDLE
my emails andy_losurdo2@hotmail.com there just to small to read on here if u got larger versions please send