Thursday, February 16, 2012 - 08:52 pm, by: Aaron Casey(Blownminiturbo)
Umm you will have to drill holes in bottom of your bumper to allow studs to go through. I did it to my brothers. Just start from one side get it flush and keep drilling as you go along, then put the brackets in at the back and bolt it together
Thursday, February 16, 2012 - 08:55 pm, by: Lewis Thompson(Lewythompson)
this lip is from this bumper it already has the holes. no idea why it has been taken off? i just dont know where these bars are supposed to fit in? and if i need to get screws?
some of the bars have threaded bits on them but they are not screws they are fixed
Friday, February 17, 2012 - 12:01 am, by: Aaron Casey(Blownminiturbo)
The studs go through and has nuts that go on them to tighten them. Ill get pics of the back of the one on my track car i have off at the moment and post it to u on facebook mate