Yes, they will fit, but they will scrub on the front guards if lowered too far. I've never put a 35mm offset rear on mine so can't say what they'll do.
Tuesday, September 26, 2006 - 10:19 am, by: Kyle Lowery(Lowery)
I had 20's on my old soarer with low coilovers and it handled perfect but you should reroute the wiring harness that goes over the front drivers side wheel arch because as soon as you hit a bump it cuts the whole harness good fun in the dark when your headlights just turn off doing 80km
Tuesday, September 26, 2006 - 02:29 pm, by: Gregg Holden(Xzotic)
The bonnet release cable is up there as well - behind the guards. I had my guards removed with 19"s and then one day wrapped the bonnet cable around the front right after hitting a large depression in the road... ...The force ripped it from it's connection on the inside...Lots of fun..
The wheels are +45mm offset (close to factory spec) and the guards have not been rolled. If I lower the car enough, it will scrub slightly if going over a large bump. With 275 tyres, it does not scrub at all (I've tried both widths). Not running much negative camber at all... I want the tyres to last as long as possible, so just told the alignment guy that, and he set it up for maximum wear.
Thanks for the compliments. That's factory (11 year old) paint.
Don Bagnall Moderator New Zealand I have WAY less Soarers than Hayden :-(
Wednesday, October 18, 2006 - 04:50 pm, by: Shane McInnes(Soarin_tt)
Simon, can you send me some full sized pics aswell? Ive had your car as my desktop wallpaper since you showed me the Auto salon shoot on MSN. But be good to have some full size pics.
Previous
