Hi everyone, I finally got around to installing my ASE664 controller todaybut I'm having trouble trying to figure out the functions that it has.
I do have a translated copy of the manual (thanks again Benny Gammelmark) but these don't seem to correspond with the controller ie: the manual says that 9 is the lowest but I can only go to 5 and I can't find the super low setting. So I was hoping that a fellow member that owns one of these controllers could give me a few tips on how to use it.
The unit decides which mode it is in when it is first powered on and will keep this until its reset or powered off completely (ie battery out).
To reset, hold down either a set or 2 buttons or all 4, i cant remember. It should beep at you anyway. Then you will have a choice of normal or special, press the up button and it will switch to SPL and you're set.
I have it set on 5 for the fronts and 6 on the rear, sits quite nice and doesnt scrape too many places but i dont have a front lip.
Enjoy, its a good bit of kit.
Daniel Lee Goo Roo Victoria Soarer GT Limited UZZ31 V8