Friday, December 28, 2007 - 11:11 pm, by: Jeremy Abram(Jem)
Just a couple of quick questions regarding fitting Tein SuperStreet coilovers to my UZZ31. Do I need anything other than what is supplied in the box from Tein, such as topmounts etc, or is it a direct bolt on?
Also if I remove the air suspension pump, will I get an error in the dash display, if so how do you remove it?
Saturday, December 29, 2007 - 06:13 am, by: Ben Lipman(Ben12a)
Jeremy,
I fitted these in my JZZ30 and needed no extra parts. I went from factory coils to the Teins though. I am not familiar with the airbag setup. Hopefully some one will come along who has changed from bags to coils soon.
Saturday, December 29, 2007 - 10:46 am, by: Ben Gardner(Gardna)
i just went from airbags to hks hyper d's and all i did was pull the airbag struts out and pull the fuse out for the suspension, and replaced with the coil overs.... piece of cake took all of two hours, unfortunately i dont know the location of the air compressor but the way i did it i get no error messages. hope this helps,