Thursday, October 21, 2010 - 02:27 pm, by: Kyle Wathen(Cspot)
I recently installed an ASI65X (M2) Height Controller into my 97 UZZ31.
The issue is it is coming up with the TEMS/Suspension error code on the dash when the height controller and loom are plugged in. If I plug the factory loom back in and reset the battery all returns to normal with no errors.
Has anyone had this issue before? I have seen quite a few other members run these units so would not think its specifically related to a 97 UZZ31.
I can confirm I have already done the following... 1. Reset battery before installing piggyback loom and controller unit 2. Connected it to the suspension computer in the rear trim 3. Fuses etc are fine as all works well once the factory loom is plugged back in (no errors)
Evan Kaio DieHard Beautiful sunny good @ rugby 'Canes' country '91 UZZ31. 92 TT
Friday, October 22, 2010 - 04:36 pm, by: Steve Howard(Greentea)
hey kyle, i tried a controller in my 97 31, jumped around all over the place, then settled down....left side down to bumpstops, right side up like a grasshopper. changed the settings, and it went the other way...could not get it level side to side. front to back was ok. hope that helps.