Friday, December 30, 2005 - 11:27 pm, by: Ben Evans(Sbyder)
Cant be replaced. Even if you could, good luck finding the part numbers lol.
NOTE: if you get some 2nd hand arms, make sure they are straight. i bought one from a wrecker and it turned out, after 3 hrs of replacing my old one with the "new" one (VERY HARD TO DO), it was 3mm bent. Had to find another...word of warning
Monday, February 20, 2006 - 04:49 pm, by: Mark Donovan(Mark_donovan)
thanks again, Don. I owe you many a beer or drink of your choice.
Do you, or anyone else, have a picture of the part at fault or can you point me to one?
I'm expecting this will cost me my left nut and will of course be ex-Japan, so I will have to go ahead with my long trip south with a munted ball joint until I get back.