Saturday, May 26, 2012 - 10:24 am, by: Dave Rose(Sand_groper)
Cant see all 4 being wrong , its looking like the height computer is u/s, i would disconnect one rear rod have fully down (hanging) try that first,next i would check the height switch and connections (it may be stuck on high)try it disconnected.
Sunday, May 27, 2012 - 09:45 am, by: Greg Wyllie(Bearshead)
I got a bit scientific this morning and measured floor to top of wheel arch......the height switch is working but difference between high and normal is only 15mm, if this about right? The pump only cuts in for a few seconds and is super quiet, I was expecting it to be 50mm or more