Tuesday, October 23, 2012 - 06:50 pm, by: Cameron Cross(Cameron_allan)
Symptoms O/D Light starts flashing Car wont rev past 3000rpm using alot of fuel stuck in 3rd gear unless manual select turn o/d off ecu light goes off, but car still in limp mode.
have replaced solenoid #2 (mv automotive) checked all wires for loose connections.
Tuesday, October 23, 2012 - 07:49 pm, by: Cameron Cross(Cameron_allan)
i had a look at the ecu when it was out it looked good, dose any one have one i can borrow for half an hour, for a auto tt to see if it is before i buy one. I'm already out of pocket $1000 and no result
Thursday, October 25, 2012 - 03:01 pm, by: Cameron Cross(Cameron_allan)
What we have checked so far we checked power from the connectors on each solenoid s1 6.4volts s2 6.4 volts s3 6.4volts ohms test on solenoids s1 13ohms s2 15ohms s3 17ohms
have piggy backed cable into back of ecu s2 checked for closed circuit. all good.
have swapped s1 and s2 to see if different error code. still produces code 63.
have checked wiring harness for any loose connections.
owned car for 6 months has been running rich since bought. only started doing the code error after i drove it from newcastle to melbourne. any help.