Tuesday, November 14, 2006 - 07:58 pm, by: James Johnson(Jamesy)
I'm in a bit of a pickle when i took the turbos off the oil return rubber hoses broke into pieces and are unusable agan. where can i get a replacement? i went to enzed and they done have hose in the right size. as well i think the stock hose has a 45degree kink in it so its hard to replace?
i have also lost the gaskets that go inbertween the turbos and the dump. what can i use to replace them? or where can i get replacements? thanks! n
Ben Socratous Goo Roo SA I am the fibreglass/kevlar/carbonfibre king!
Tuesday, November 14, 2006 - 09:50 pm, by: Ben Socratous(Socrates)
Hey man, good to finally meet you on the weekend!
Tried pirtek, or anyone else?
Any hose joint should be able to make you a hose with the requiered bend in it. Other than that, a wrecker, Mr T, another unsuspecting TT when no one is looking...
Wednesday, November 15, 2006 - 03:51 pm, by: Braden Murdoch(Ribfeast)
Apparently you are not supposed to use radiator hose. I broke an oil hose elbow (perhaps the same as yours) of my oil return line when replaced the turbos a few months back and used radiator hose, it is holding up fine as it is not under pressure.
Wednesday, November 15, 2006 - 08:53 pm, by: James Johnson(Jamesy)
thanks lew, I ended up getting some oil hose from enzed its slightly too small but i heated it up and squeezed it on very tight but atleast it wont leak!
Thursday, November 16, 2006 - 08:06 am, by: Lew Radbourn(Marlew)
James just make sure you don't have any kinks in the hose after it is fitted. and just do a check on it in a months time the original hose is silicon. to withstand the heat from the turbo. good luck mate.