Saturday, May 10, 2008 - 12:04 pm, by: Maurice Diggler(Mau_rice)
Remove the vacuum line that goes to the back of the boost gauge, trace it back thru the firewall to it's source then block it off and take the hose out or else you will have a leak. Then cut the power wires (with the power off) remove them if necessary or just tape them up seperately and tuck them away.
Saturday, May 10, 2008 - 04:31 pm, by: Charlie Ters(Ul05st)
make sure there are 0 <--- leaks (might as well buy a new piece of hose and cancel out the T piece) as this looks like your fuel reg hose which is a big NO NO when hooking up boost gauges anyways