Wednesday, August 05, 2009 - 07:36 am, by: Sebastian Grant(Saabg)
I have no idea what this random nut is that's tapped into the exhaust housing. It's hollow, could it be for a sensor? It's not oil or water so what is it and what do I do about it? I'm thinking of just bolting it up? Any ideas?
These are hks t3gs by the way but I have not seen this thread on any other t3gs.
Wednesday, August 05, 2009 - 03:31 pm, by: Sebastian Grant(Saabg)
Thanks Cihan and Christian. That is a bit confusing as I haven't seen this on any other set of t3gs. Where do most people run the actuators too? There's no provision for a feed from the inlet housing like on the ct12as. Do I have to tap into the inlet manifold?