Rating: N/AVotes: 0 (Vote!)
Tai Johnsen wrote on Thursday, September 24, 2009 - 09:15 am:It can... Juuust I had to remove a very small amount of material crom the cross member to squeeze it past though. On the rear part of the crossmember was rough parts from the mould.. I just ground it off with an alloy wheel and grinder.
It can... Juuust I had to remove a very small amount of material crom the cross member to squeeze it past though. On the rear part of the crossmember was rough parts from the mould.. I just ground it off with an alloy wheel and grinder.